Bachelorette Superstore Penis Ice Luge Mold Decorations

 IN SOME CASES THIS ITEM WILL SHIP SEPARATE FROM THE REST OF YOUR ORDER DUE TO THE FRAGILITY OF THE MOLD. WE WILL CONTACT YOU FOR SHIPPING COST IF APPLICABLE. 

Sure to make your next Bachelorette or adult party a wild one! Use this Penis ice luge to serve your shots or drinks Ice Cold! Each Penis ice luge is roughly 12″ tall and 12″ wide. Put an LED light under it and it makes a wonderful centerpiece to your bar or drinking area. (LED light not included, you MUST check the box above for it to be added to your order. LED lights cost $5.00.

INSTRUCTIONS:
There are just a few things to keep in mind when creating your Ice Luge Masterpiece. Follow these instructions for a flawless experience!
1. FILLING- Remember, your ice luge is frozen in 2 steps over 48hours
a. Fill halfway and freeze for 24hours
b. Fill to the top with COLD WATER and freeze for another 24hours
If you use warm water it will crack
2. DE-MOLDING – Ice is very sensitive and cracks easily when leaving a freeze. So when removing your ice luge sculpture from the mold, follow the directions carefully.
a. Gently removed luge from freezer.
b. Allow the mold to acclimate outside of freezer for 10-15mins.
c. Using a utility knife and/or scissors, cut along seam of mold. Gently peel away.
d. Clean up or buff up any rough spots or residue with a damp towel.
e. Straighten the aluminum at the end of mold, and pull the aluminum wire using the handle or pliers.
f. Pull tubing out. Pull from both ends to loosen if needed.
g. Place back into freezer, gently, if you will not be using immediately.
3. USING YOUR LUGEZ ICE LUGE!!!!
a. Place luge on a tray. Dark colors look the best.
TIPS:
Place a towel under the tray to reduce a watery mess.
Use cold liquids to preserve the luge as long as possible.
GET YOUR CAMERA READY & ENJOY!!!